Article

What the US air traffic control outage can teach organisations about the PSTN switch-off

Abstract network visualization representing AI transformation

17th November 2026 | by Matt Fooks

4 Minute Read

What the US air traffic control outage can teach organisations about the PSTN switch-off

What the US air traffic control outage can teach organisations about the PSTN switch-off 

The US ground stop on 13 November began with a routine copper-to-fibre upgrade. Here is what it shows about moving your remaining lines off the PSTN. 3-minute read. 

On 13 November the US halted every departing flight in the country for more than four hours. The cause was not old copper failing, but the work to replace it. 

America's air traffic control network is going through its own version of the PSTN switch-off. Its copper circuits are being discontinued, and contractor L3Harris is moving FAA sites onto fibre, wireless and satellite links. The programme is around 70% complete. 

What happened 

During a routine cutover at a remote site in Arkansas, a newly installed router began sending around 1,000 connection attempts every four to five seconds. Older equipment elsewhere on the network could not cope. Voice and radar feeds became unreliable at control centres across the country, and the FAA stopped departures. Officials had not expected the work to have much impact. 

Once the source was found and disabled, the network settled, but around 12,000 flights did not operate. Whether the router or its installation was at fault is still under investigation. 

Why it matters for UK businesses 

The UK's PSTN closes on 31 January 2027. Openreach says around one million copper lines are still active, 300,000 of them at business premises, and that what remains are "the complex connections that underpin critical operations". 

We are migrating customers off the PSTN now. On some sites, nobody can say for certain what a line carries or what else depends on it. A migration will not ground a country's flights, but it can stop something important working on a site. 

Know what runs on every line 

A line that looks like a phone line may be doing something else. The one labelled "fax" could be how the alarm panel reaches its monitoring centre. A card terminal may only use it as a backup when broadband drops, so it can pass a test and still fail when it matters. Lift phones, door entry and building management systems hide in the same way. 

Trace each line to the equipment at the end of it and write down what you find. The FAA logs maintenance by hand; during the outage, staff had to search paper records to work out who had been working on what. 

Know what the change touches 

The replacement adds equipment to your network and runs on your mains power and broadband, where the old line was powered from the exchange. A lift phone that worked through a power cut may not, without battery backup. 

New equipment can also unsettle what is already there, as it did in the US. Check what shares the network, power and cabling with anything you change. 

Isolate the change and keep a way back 

Move one service at a time where you can, so a problem has one likely cause. Test each device end to end with whoever is at the other end, such as the alarm receiving centre or payment provider, not just for a dial tone. Keep the old service until the new one is proven, and agree in advance how you will reverse the change. Do the work when failure costs least; US officials have said they will review when this kind of work is done. 

That way back has a deadline. After 31 January there is no PSTN to fall back on, and the worst time to find out what a line was doing is after it has been switched off. 

If you have lines still to move and are not sure what is on them, speak to your VCG account manager.

Meet the Author

Matt Fooks

Matt Fooks

Technical Director

Share this page